ARDUINO BEGINNER PRJECT || HOW TO MAKE A BLINKING LED || TINKERCAD

 Requirements:

1. Arduino Uno R3
2. LED
3. Resistor - 220 ohms

• Connect the LED anode terminal to the resistor then to a digital pin on the arduino. e.g., Pin 13.
• Connect the LED cathode terminal Ground (GND) pin of the Arduino.
• Copy paste the following text code.

void setup()
{
  pinMode(13, OUTPUT); //set the digital pin 13 as an output
}
void loop(){
  digitalWrite(13, HIGH); //turn the LED on
  delay(1000);//wait for 1 second (1000 miliseconds)
  digitalWrite(13, LOW); //turn the LED off
  delay(1000); //wait for 1 second (1000 miliseconds)
}